"wylieb" <guest@unknown-email.com> wrote in message
news:52488e479321b832555ea2743d33fcfa@nntp-gateway.com...[color=blue]
>
> Oh Thank you thank you. After reading here (I'm a new member) I see Im
> not alone.
> PROBLEM: I can't connect to more than two of my computers at a time.
> I have two XP and two Vista - it would be interesting if I had a third
> Xp to see if I can connect to three (xp) at a time . . . bet I could.
> I've never had a problem connecting my two XP computers wireless but
> maybe i was just lucky. (or maybe what I hear about Vista is true)
>
> I'm using W54G, WPA2, all new updates, DHCP (and tried IP as well).
> Simple home wireless network. I set and reset up "home network" via USB
> and manually. All units see each other and I turned all firewalls
> -*off.*- All units connect well, but only two at a time can go to
> (broadband) internet. ie, all 4 connect to my wireless connection but
> broadband has to be disconnected from at least one of two computers
> before another (third) computer can connect. I can ping the 54G from
> anywhere. Please don't suggest I ping otherwise, that has only served
> to confuse me (people say ping yahoo or the modem - it tells me nothing)
>
>
>
> Why does more than one computer (other than the base unit) have to
> connect to broadband anyway if it is connected to the router? I thought
> the router split the signal 4-ways and only the base unit should be
> connected to broadband? If so, I thought that when I purchase
> broadband, that only one subscriber (hence one computer) can use it, not
> two?
>
> And therefor, I can find no way in the world to just connect to my
> wireless connection and by-pass/disable the broadband on other than the
> base unit - am I doing something inherantly wrong? I can't find any
> info anywhere that describes this but again, I reiterate: my thinking is
> that the base computer connects to broadband account and the router
> splits this into 4 and the other computers just have to connect to the
> W54G, not to broadband.
>
> So many questions in this new Vista wireless networking world. Thx in
> advance for your guidance. signed, CIC "confused in china"
>
>
> --
> wylieb[/color]

Your post rambles on badly so I will only specify how to set up a network
physically. The output from the broadband modem/device should not be
plugged into a computer but the WAP (W54G).

What ever broadband modem device you have (cable, T1, FIOS, DSL) should be
plugged into the input RJ45 port (IIRC Yellow in color) on the back of the
W54G. Any wired computer is plugged into the remainder of the RJ45 ports on
the back. The wireless is then set up and any number of WPA2 set up
wireless devices should be able to access the WAP (W54G) at the same time.
I have at least 10 wireless devices (5 laptops and one desktop use wireless
on a daily basis) two wired computers and 3 NAS wired devices on the network
that can access my home network and the internet at the same time.