I have downloaded the latest Vista driver for the Audigy 2, which is a self
extracting file. When I run it, I always get the same error message:
file error[@s]crc1,0xc50a2d15:0x0d8c70c
and then the process aborts. When I download and run the file on my XP
machine, it runs just fine and brings up the installation program. Any ideas
on how I can get this thing to run under Vista. I went this route because I
was never able to get the onboard Realtek '97 audio to work. Under that
scenario, Control panel says the device is working properly and there are no
conflicts, but the speaker icon in the system tray has a red x over it, and I
get no sound. I would gladly accept a solution to either problem so I can get
the audio working.
Chuck

/Chuckf1234/ said:[color=blue]
> I have downloaded the latest Vista driver for the Audigy 2, which is a self
> extracting file. When I run it, I always get the same error message:
> file error[@s]crc1,0xc50a2d15:0x0d8c70c
> and then the process aborts. When I download and run the file on my XP
> machine, it runs just fine and brings up the installation program. Any ideas
> on how I can get this thing to run under Vista. I went this route because I
> was never able to get the onboard Realtek '97 audio to work. Under that
> scenario, Control panel says the device is working properly and there are no
> conflicts, but the speaker icon in the system tray has a red x over it, and I
> get no sound. I would gladly accept a solution to either problem so I can get
> the audio working.[/color]

[url]http://forums.creative.com/creativelabs/board?board.id=Vista&page_of_message_id=2113[/url]