Hey all,

Very new to the Norton Ghost cloning procedure and having trouble. I have two m200s- one 2.0 ghz with a 60gb (7200) drive, and the other a 1.6 with a 40gb (5400) drive. I am trying to clone my 2.0 to my 1.6 via a peer-to-peer TCP/IP connection.
After I go through the motions, selecting the Intel Pro 100 driver and rebooting in DOS (from Ghost 2003 software), the screen says cannot find the NIC driver. Then when Ghost comes up in DOS, the Peer-to-peer option is greyed out and cannot be selected.

So I created a floppy boot disc (2 disc set) with the Intel Pro 100 drivers to boot from the Ghost Boot Wizard, and the same thing happens when I restart from the floppy- unable to locate the cannot NIC.

IBM protocol manager Version 2.1
MAC/DIS to Packet Driver converter loaded. Version 1.18

Intel Pro PCI driver v.427 062101

It says possible causes could be:
1) The system may not support the PCI bus.
2) The NIC may no be properly installed in a slot. (my internet connection works fine)
3) Some of the NIC resources in configuration space may be invalid. (what?)
DRIVER DID NOT LOAD, NDIS environment invalid.
MS-DOS LAN MANAGER v2.1 netbind
IBM netbind version 2.1
Error: 33 Unable to bind.

Is there something I'm doing wrong, or is it an M200 thing? Is there another way to do it between these two machines?

Please help, and remember to be very basic as I am not very knowledgeable yet.

Much thanks- Roy